NEON TRIO

Versatile water-resistant NEON-strip

The light of the LIMENTE NEON Trio is even and soft, and therefore does not cause glare even when directed toward the viewer. The product’s lifespan and technical lighting characteristics, such as color rendering, are also optimized to the highest possible level. Thanks to its enclosure rating (IP67), it is suitable not only for installation in wet areas but also for outdoor use.

NEON-TRIO is slightly larger than NEON-LITE, and its profile directs light in three different directions. Designed for ambient and auxiliary lighting, the profile is ideal for applications such as light strips or indirect lighting behind mirrors, on bathroom walls and ceilings, under eaves, on railings, staircases, and similar locations.

The power supply cable located at both ends allows the NEON TRIO to be used in two separate sections when needed. This helps avoid unnecessary waste and enables installation of the strip in two different directions from a single power source.
NOTE: The power supply must always be ordered separately.

Dimming and lighting control

LIMENTE NEON TRIO is designed from the outset as ambient lighting, so dimming is not strictly necessary. However, by adjusting the NEON, you can fine-tune the lighting and create illumination that suits different situations in your home. A stepless dimmer makes it easy to create atmosphere and give a space a new look. By dimming LIMENTE luminaires, you can transform your home lighting from efficient and bright to soft and cozy. If desired, the same controller can be used to adjust all LIMENTE luminaires in the room, including various ceiling, panel, and under-cabinet lights. The luminaires dim smoothly and evenly, enhancing the atmosphere of the entire space.

The NEON TRIO power supply cable does not include a quick connector, so sufficient expertise is required for installing the dimmer. During installation, the distribution block on the Smart dimmer must be removed and replaced with the TRIO power supply cable. Be sure to observe correct polarity, as incorrect wiring will damage the NEON. Please also note that the dimmers are designed for installation in dry indoor areas only (IP20).

Installation

Installation of the LIMENTE NEON TRIO is quick and easy. The mounting clips included with the light strip are installed in place, after which the NEON strip is pressed into the clips. Finally, the power supply cable is connected to the light strip and the power supply using the distribution block included.

The NEON TRIO can be cut at 5 cm intervals and features power supply connections at both ends, allowing each end to be used separately if needed.

Please note that the power supply does not include a plug, and installation may only be carried out by a person with sufficient professional expertise.